How to install a kitchen sink

The sink is one of the indispensable supplies in the kitchen, we want to install the kitchen sink ourselves, however, we do not know very well the installation steps of the kitchen sink, then how to install the kitchen sink. The following is to introduce you to eight installation steps.

Here is the content:

• Before installing the sink

• Faucet

• Overflow pipe

• Filter blue

• Drainage pipe

• Drainage experiment

Before installing the sink

Before installing the kitchen sink, the faucet and the inlet pipe should be installed. So that the installation at the back will not be troublesome. When installing the faucet, request the installation of solid, in the connection cannot present the phenomenon of water seepage. Generally, take sealant or professional adhesive glue. The faucet purchase to pay attention to the installation of the best-fixed accessories required for pure copper or stainless steel because the stainless-steel sink uses more water, so it is not easy to rust. General into the water pipe is one body into the water pipe, there is no need to install.

After installing the kitchen sink with some functional accessories, you can place the sink in the corresponding position on the countertop.

Faucet

First, install the inlet pipe of the faucet. Will be previously installed in the faucet into the water pipe end connected to the inlet pipe switch outlet, installation should pay attention to the articulation of the firm, not too tight or too loose, and there is a point to note is the location of the hot and cold-water pipe, should be left hot right cold.

Overflow pipe

Then install the overflow pipe. When installing the overflow pipe, pay attention to the sealing of its connection with the tank, to ensure that the overflow pipe itself does not leak. Then seal it with glass glue.

Filter blue

Next, install the filter blue. It is necessary to check the downpipe under the filter basket, and pay attention to the connection between the downpipe and the tank body, not only to be firm but also to be sealed. A general leak presents a lot of problems are presented here.

Drainage pipe

Install the overall drainage pipe, due to the difference between the kitchen sink and the space below the stainless-steel sink, the drainage pipe can be cut in an appropriate amount to protect the integrity of the case.

Drainage experiment

At the end of the installation, a drainage test is conducted to test the drainage of water from two or one filter basket as well as water from the overflow hole. Drainage, if found where there is the phenomenon of water seepage, the horse long to test, and then finally fasten the fixed cap, in the change of sealing place to seal.

Ensure that there is no problem, you can seal the edge of the stainless-steel sink. The use of glue is recommended to use a more solid glass glue, pay attention to the seam to apply evenly.

It is the responsibility of every manufacturer to produce kitchen sinks that meet the standards to ensure the healthy development of the market. Our company has conducted several tests on the products before leaving the factory, and the quality pass rate is guaranteed. If you need a kitchen sink, you can consider our cost-effective products.